Stationary hot water heater with one exchanger suitable for different heat sources.
 |
The anti-corrosion layer is not subject to pitting corrosion in hard and chlorinated water. |  |
High-quality Covestro insulation for low heat loss and minimum operating costs |
 |
Suitable for boilers |  |
Also suitable for condensing boilers |
 |
Single-exchanger heater |
More information
More information about the OKC NTR indirect heater
- In models 100, 125, 160 and 200
- In models from 200 above, two exchangers can be used to connect two sources of heating water (e.g. gas boiler + an alternative source). When the two exchangers are connected in series, a DHW source of up to 44 kW can be obtained
- In models 100, 125 and 160, utility water inlet and outlet are located in the upper lid
- Models 100, 125 and 160 have a drain hole
- The heater is equipped with a temperature control for the heating of DHW (thermostat for controlling the three-way valve or circulation pump) for the voltage of 230 V/50 Hz, safety valve and outlet for circulation
